MB1936

Applicable for

MB1936 board overview.

1. Board overview[edit | edit source]

Main board MB1936, revision C-01: part of the STM32MP257x-EV1 Evaluation board .


Position	Description	Position	Description
1 (LED1)	User LED (blue) ^{[* 1]}	2 (LD1)	User LED (red) ^{[* 1]}
3 (LD2)	User LED (orange) ^{[* 1]}	4 (LD3)	User LED (green) ^{[* 1]}
5 (B1)	RESET button	6 (B2)	WAKE UP button
7(B3)	TAMPER button	8 (B4)	USER2 button
9 (B5)	USER1 button	10 (CN2)	LVDS connector
11(CN4)	CSI connector	12(CN3)	DSI connector
13 (CN1)	microSD card connector	14 (SW1)	Boot mode selection
15 (U22)	S-NOR 512Mb	16 (CN5)	GPIO Expansion connector
17 (CN9)	FDCAN1	18 (CN11)	FDCAN2
19 (U26)	STPMIC25	20 (U27)	STM32MP257
21 (U24)	eMMC 4GB	22 (U29)	DDR4 2GB
23(U28)	DDR4 2GB	24 (CN10)	PWR measurements connector
25 (CN22)	MIPI10 connector	26 (CN13)	Mini-PCIe connector
27 (JP4)	Power Jumper	28 (CN20)	5V/3A Power Supply Jack
29 (CN21)	USB Power – ST-LINK TypeC	30 (CN16)	ETHERNET 2 / PHY ETH2
31 (CN17)	ETHERNET 1 / PHY ETH1	32 (CN18)	ETHERNET 3 / PHY ETH3
33 (CN19)	Dual USB Host TypeA	34 (CN15)	USB2.0 DRD TypeC
35 (LD7)	Ethernet LED (green)^{[* 2]}	36 (LD8)	Ethernet LED (green)^{[* 2]}
37 (LD9)	Ethernet LED (green)^{[* 2]}	38 (LD11)	Power LED (green)^{[* 3]}
39 (LD5)	ST-LINK/V3-1 LED (bicolor)^{[* 4]}

Details about some LEDs:

↑ ^1.0 ^1.1 ^1.2 ^1.3 LD2, LD3, LD4, LD5 (MB1936): some user LEDs are used to reflect the system activity, while the others are left free to be used by the application, as explained in LEDs and buttons on STM32 MPU boards article
↑ ^2.0 ^2.1 ^2.2 LD7, LD8, LD9 (MB1936): flashes green when Ethernet connection established
↑ LD11 (MB1936): turns green if power connection established
↑ LD6 (MB1263): flashes red if ST-LINK/V3-1 connection not established, else green

STM32MP257x-EV1 Evaluation board front side
STM32MP257F-EV1 shown here (picture is not contractual)

STM32MP257x-EV1 Evaluation board back side
STM32MP257A-EV1 shown here (picture is not contractual)

Position	Description
40(CN25)	mikroBUS connector